Manual TO3100 - DResearch
Manual TO3100 - DResearch
Manual TO3100 - DResearch
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>DResearch</strong> – User manual TeleObserver <strong>TO3100</strong> 2011-02-03<br />
4 The device service menu<br />
Ask your administrator before undertaking changes in the network configuration of the device or<br />
the local computer.<br />
If you want to operate the system in a network environment or with a Laptop through the Ethernet<br />
interface it may be necessary to adapt the device to a specified network structure. Changes of the<br />
network settings are performed by using the internal service menu of the system. There are two<br />
possibilities to configure the IP-address:<br />
4.1 Service connection using serial interface COM1 (service cable)<br />
� Connect the PC or the Laptop to the COM1 interface of the <strong>TO3100</strong> device by using the<br />
service cable (<strong>TO3100</strong> accessory).<br />
� Start the program Hyperterminal (Start / Programs / Accessories / Communication …) or<br />
another terminal program. Establish a connection to the COM interface of your PC where the<br />
service cable is connected.<br />
� Click ENTER. If the settings are correct, a LOGIN prompt appears.<br />
Insert service and click ENTER.<br />
Further steps are stated below.<br />
4.2 Service connection using ethernet interface (X-link cable)<br />
The system is preconfigured in its delivery status and has an IP-address and a network address. The<br />
The factoy default IP-address is noted down in the delivery note and inside of the flap of the hard disk<br />
drive. Please mention that the service computer and the <strong>TO3100</strong> system must have IP-addresses into<br />
the same network segment.<br />
30