Instruction Book DC2010 - Janome

Winding the BobbinRemoving the bobbinSlide the hook cover release button to the right, andremove the hook cover.Lift the bobbin out.q Hook cover release buttonw Hook covere BobbinwqeSetting the spool of threadPlace the spool of thread on the spool pin with thethread coming off the spool as shown.• For an ordinary spool:Use the large spool holder.q Large spool holder• For a narrow or small spool:Use the small spool holder.w Small spool holderqw• Additional spool pinThe additional spool pin is for bobbin winding, withoutunthreading the machine, and for twin needle sewing.Set the spool stand under the additional spool pin,place the felt, then insert into the hole.q Spoolw Additional spool pine Feltr Spool standt Hole for the additional spool pinrqwetWinding the bobbinNOTE:Set the speed control lever at for bobbin winding.z Guide the thread around the bobbin winder threadguide.q Bobbin winder thread guidex Insert the thread through the hole on the bobbin,threading from the inside to the outside. Put thebobbin on the bobbin winder spindle.w Bobbin winder spindlec Push the bobbin winder spindle to the right. TheLED display shows .v With the free end of the thread held in your hand,depress the foot control. Stop the machine whenthe bobbin has made a few turns, and cut thethread close to the hole on the bobbin.b Depress the foot control again. When the bobbin isfully wound, it will stop automatically. Return thebobbin to its original position by moving the spindleto the left, and cut the thread as shown.xvzqwcbx20