Instruction Book DC2010 - Janome

Threading the MachineThreading the machineq Spoolw Spool holdere Presser foot lifterczwqebxvz Raise the presser foot.Press the Up/Down needle position button tobring the take-up lever to its highest position.Turn the power switch OFF.Draw the end of the thread with your left hand andhook around the upper thread guide while holdingthe thread at the spool with your right hand. Passthe thread down into the slot.r Upper thread guidet Slotzrtx Draw the end of the thread down around the threadguide plate and draw it up to the left.Make sure the thread slips in between the tensiondisks.y Thread guide plateu Tension disksxyuc Firmly draw the thread up to the take-up lever,and down into the eye of the thread take-up leverfrom the right to left.i Thread take-up leverc3iv Pass the thread in the lower thread guide from theright.o Lower thread guideb Slip the thread in the needle bar thread guide onthe left.!0 Needle bar thread guidev bo!0NOTE:Refer to page 26 for the automatic needle threader.24