Instruction Book DC2010 - Janome

Problems and Warning SignalsWhen beep sounds and the LED display shows warning signal, follow the guidance below to deal with.Visual signalLEDCause and ActionThe foot control has been disconnected while sewing.Turn OFF the power and connect the foot control.A button is pressed when the machine halts due to the overload.Wait for at least 15 seconds to recover.If thread jamming causes overload, remove the tangled threads.The Up (+) or Down (–) key is pressed after buttonhole is finished but the foot is notraised.Raise the foot.Do not use the automatic buttonhole foot to sew any other pattern than buttonhole ordarning.The machine is out of order.Audible signalBEEPBeep sounds when:pippip-pip-pippip-pip-peeppeepNormal operationInvalid operationButtonhole is finished.The machine is out of order.80