Instruction Book DC2010 - Janome

z Raise the needle and foot. Place the automaticbuttonhole foot with its pin just under the groove ofthe foot holder. Lower the presser bar to attach thefoot.q Groovew Pinzqwx Pull the button holder open to the back (A), andplace the button in it. Push the button holderclosed (B) to hold the button.e Button holderxNOTE:If the button is extremely thick, make a testbuttonhole. If it is difficult to fit the button through thetest buttonhole, lengthen the buttonhole by pullingthe button holder back to create a gap.r GapAeBrc Pull the buttonhole lever downward as far as it willgo.t Buttonhole leverctv Raise the buttonhole foot and draw the needlethread to the left through the hole on the foot.Place the fabric under the foot and lower theneedle at the starting point. Then lower the foot.y Buttonhole marku Starting pointi Slidero No gap!0 Spring holder!1 Sewing gapvy←!0ioNOTE:Make sure there is no gap between the slider andspring holder, otherwise the left and right length ofthe buttonhole will be different.u!146