Guide d'utilisation Fr - 3 User's guide Gb - 19 Manual de ... - Num'Axes

(Gb - 25 F button: Flash stimulationPress the «F» button to send a warning to your dog using stimulations transmitted by the two contactpoints located on the receiver collar for a defined length of time of less than one second.A « transmission » symbol will appear on the LCD screen of the remote control; the indicator light on thecollar goes from flashing green to permanent red while the stimulations are being sent. C button: Continuous stimulationPress the «C» button to send a warning to your dog using stimulations transmitted by the two contactpoints located on the receiver collar, this will last for as long as the button is pressed but limited to8 seconds maximum.If you press the «C» button for more than 8 seconds, the collar will automatically go into safety mode fora few seconds before restarting itself normally.Nota: Beeps can be associated to the stimulation by pressing first the “C” button and then thebutton. « Booster » buttonPress the Booster button to stop your dog instantaneously. You can choose the stimulation level youthink to be the best for an immediate effect. As a result, you do not need to press the « + » button. Thosestimulations are transmitted by the two contact points located on the collar for as a long as the buttonis pressed but no more than 8 seconds max.If you press the « Booster » button for more than 8 seconds, the collar will automatically go into safetymode for a few seconds before restarting itself normally.« Booster » button configuration:- select the stimulation level 01- press the ”-“ button until the stimulation level flashes on the LCD screen- press the ”+“ or ”-“ button to modify the stimulation level- press the « Booster » button to confirm the level selected « + » and « - » : stimulation level control buttonsUse the “+”/”-“ buttons for rapid adjustment of the stimulation level of the receiver collar.15 levels are available.Level 1: very weak stimulation. Level 15: strong stimulation.Always start with the lowest level of stimulation. Retro-lightning of the LCD screenYou can light the LCD screen for approximately 6 seconds by pressing briefly the On/off switch ( ((approx. 1/2 second).)