Bedienungsanleitung KXE - REITZ Ventilatoren

3. Transport, Installation
3.1 General remarks
3.2 Safety instructions
BWA-KXE-Fetteinzelstehlager_englisch_02.doc
Transport, Installation
The fan and the equipment should only be transported and
lifted at the provided marked lifting lugs. Load suspension
devices as well as sling devices have to be in perfect condition
and should only to be fastened at the provided lifting
lugs.
Personnel that lifts and transports the fan must:
- have read the operating manual,
- have understood the content of the chapter transport, especially
the safety regulations, the regulations for the prevention
of accidents and the instructions for the transport
of the fan,
- be familiar with the hoists, the required load suspension
devices and the sling devices.
The safety instructions for lifting and transport of the
fan must be observed.
- Use hoists, load suspension devices and sling
devices with sufficient load capacity only (for load
/ weight see fan data sheet or fan drawing)
- The angle of spread must not exceed 120° (see
Figure 2).
- Do not knot steel wire ropes and chains.
- Do not tie ropes from fibres with knots.
- Do not distort the ropes.
- Untwist distorted ropes prior to lifting.
- Do not kink the ropes at wire rope clamps.
- Thimbles (cable eye stiffeners), rope eyes, suspension
hooks and other lifting links must suspend
freely on the lifting hook.
- Use edge guards when the slings are laid on
sharp edges.
- Lift up the hook tackle when it is not used.
- Do not lift loads over people.
Observe the regulations for the prevention of accidents.
Auxiliary lifting lugs (e.g. at the motor) – if any – are suitable
only for lifting the corresponding single component.
We recommend an installation performed by
manufacturer’s skilled staff.
3.1