Power Cable Accessories

Outdoor termination for unscreened, 3-core polymeric insulated cables
6 kV and 10 kV
Cable
The indoor termination is designed for 6 kV
and 10 kV unscreened three core plastic
insulated cables with armour or copper
earth shield.
For example: АПВГ , YAKYFtly, YKYFoy,
YKYFtly, AYKCY, CYKCY, NAYFGY, PPO
41-(A), PP 44-(A), PP45-(A), N(A)YFGY.
Dimensions L, D see table
Design of termination
The cores are covered with non-tracking
insulating tubing. The area between the
end of the oversheath and the cores is
sealed and protected by a non-tracking
insulating breakout. Additional skirts are
installed onto the tubing (see table).
Nominal voltage Cross section Ordering description Dimensions (mm) No. of
Uo/U (kV) (mm 2 ) L D skirts
3,5/6
16– 50
EPKT 2292
EPKT 2294
650
1200
76
76
3 x 1
3 x 1
and
6/10
70–120
EPKT 2302
EPKT 2304
650
1200
95
95
3 x 1
3 x 1
EPKT 2312 650 95 3 x 1
150–240
EPKT 2314 1200 95 3 x 1
Note: One termination kit includes material for 3 phases. Longitudinally sealed cable lugs are to be used.
The core lengths can be reduced to the requirements at the place of installation, the minimum core length is 450 mm.
Solderless earth connection for cables with armour or copper tape shield
Nominal voltage Cross section Ordering description
Uo/U (kV) (mm2 )
3,5/6
16– 95
120–300
SMOE 60805
SMOE 60873
16 SMOE 60805
6/10 25– 95 SMOE 60873
120–300 SMOE 62176
Note: The solderless earth connection kit must be ordered separately. It includes a roll spring and an earth lead.
Terminations for motor connection boxes are available on request.
Solderless earth connections can be
ordered separately.
2 7