Power Cable Accessories

DuraSeal – pre-insulated connectors and terminals
Application
Provides an environmentally sealed core
connection for installation cables. To be
used in joints or as a sealed terminal.
Installation
Select the correct connection element.
Remove the core insulation on a length
of 7,5 mm. With the adhesive not being
sticky at room temperature, the cores can
be easily inserted into the connector.
Construction
The connector consists of a crimp barrel
and a pre-installed adhesive coated heat
shrinkable tubing.
Crimp the connector with a suitable
crimping tool, for example Raychem
AD 1522-1.
The terminal consists of a crimping lug
and a pre-installed adhesive coated heat
shrinkable tubing.
Heat the crimped connection area with a
hot air tool until the tubing recovers and
the adhesive flows. The Raychem heating
tool HL2005E-230V and the reflector
HL1802E-070519 are recommended.
Insulated connectors
Cross section (mm2 ) Ordering description Colour Length
min. max. (mm)
0,5 1 DS-18-22 red 32
1,5 2,5 DS-14-16 blue 32
4 6 DS-10-12 yellow 32
Note: To be ordered in boxes, a box contains 100 pcs or 50 pcs (only size 4–6 mm2 )
Insulated terminals
Cross section (mm2 ) Ordering description Colour
Fork Ring
min. max. d = 4 mm d = 4 mm d = 6 mm d = 8 mm
0,5 1 DF-2-40 DR-2-40 DR-2-60 DR-2-80 red
1,5 2,5 DF-6-40 DR-6-40 DR-6-60 DR-6-80 blue
4 6 DF-4-40 DR-4-40 DR-4-60 DR-4-80 yellow
Note: To be ordered in boxes, a box contains 100 pcs or 50 pcs (only size 4–6 mm 2 )
d = hole diameter
5 5