User's guide of Proceessing Modflow 5.0

Processing Modflow 61
3.2.2 The Zone Input Method
Fig. 3.8 The Search and Modify Cell Values dialog box
The Zone Input Method allows you to assign parameter values by zones. To activate this method,
choose Input Method < Zones from the Options menu. Alternatively, you may click on the
button . Zones must be designed or drawn first before assigning parameter values to them.
< To draw a zone
1. Click the assign value button .
You do not need to click this button, if its relief is already sunken.
2. Click the mouse cursor on a desired position to anchor one end of a line.
3. Move the mouse to another position then press the left mouse button again.
4. Repeat steps 2 and 3 until the zone is closed or press the right mouse button to abort.
< To delete a zone
1. Click the assign value button .
You do not need to click this button, if its relief is already sunken.
2. Move the mouse cursor into a zone.
The boundary of the zone will be highlighted. The value(s) of the current zone will be shown
on the status bar.
3. Press the Del-key.
< To assign new value(s) to a zone
1. Click the assign value button .
You do not need to click this button, if its relief is already sunken.
2. Move the mouse cursor into a zone.
The boundary of the zone will be highlighted. The value(s) of the current zone will be shown
on the status bar.
3.2 The Data Editor