Service Bulletin

More documents

Recommendations

Info

22. Put the new transformer assembly on gear case (1/2SS-3C-037 or 1SS-3C-037) beside the brake (1/2SS-1C-041 or 1SS-1C-041), then tighten the two Phillips pan head machine screws M6×10 (1/2SS-3C-042). New transformer assembly gear Figure 33 Figure 34 brake 23. Install the two new limit switches in position. New limit switch Figure 35 24. Replace capacitor and solid state switch, which was removed earlier, back into position on the new electric control assembly and tighten screws. capacitor Figure 36 10 Solid state switch -- Page 10 of 38 ---
25. Place the new electric control assembly into the correct position by the motor and orient it properly. Figure 37 26. According to the new wiring diagram on page 14, reconnect all the wires. Re-attach cable ties where needed. Figure 38 11 New electric control assembly -- Page 11 of 38 ---
Page 1 and 2: Issued by: GS Document No: 20101104
Page 3 and 4: Installation process for upgrade ki
Page 5 and 6: 7. Unscrew the screws on the transf
Page 7 and 8: 12. Cut the cable ties that tighten
Page 9: 18. Unscrew the four screws on the
Page 13 and 14: -- Page 13 of 38 --- 30. Place the
Page 17 and 18: 7. Unscrew the screws on the transf
Page 21 and 22: 19. Unscrew the nine screws on the
Page 23 and 24: 26. Install the new electric contro
Page 25 and 26: 32. Plug the power cord assembly co
Page 29 and 30: -- Page 29 of 38 --- 7. Unscrew the
Page 33 and 34: 19. Unscrew the nine screws on the
Page 35 and 36: 26. Install the new electric contro
Page 37 and 38: 32. Plug the power cord assembly co

Service Bulletin

Create successful ePaper yourself

Delete template?

Save as template?