Service Bulletin

More documents

Recommendations

Info

-- Page 28 of 38 --- 4. Unscrew the 8 Phillips pan head machine screws M6×10 (1/2SS-3C-042) from the gear side cover (1/2SS-3C-043 or 1SS-3C-043). Figure 5 5. Move the gear side cover (1/2SS-3C-043 or 1SS-3C-043) away from the hoist body. Figure 6 6. Cut the cable ties that tightened wires on the gear side. Figure 7 cable ties Figure 8 28 Phillips pan head machine screws M6×10 (1/2SS-3C-042) gear side cover (1/2SS-3C-043 or 1SS-3C-043). gear side cover (1/2SS-3C-102 or 1SS-3C-043).
-- Page 29 of 38 --- 7. Unscrew the screws on the transformer and pull the wires out of the terminals on the transformer, including the two grounding wires. Figure 9 Figure 10 grounding wire Figure 11 Figure 12 8. Disconnect the two bullet quick connectors that connected the brake wires. Figure 13 bullet quick connectors Figure 14 29
Page 1 and 2: Issued by: GS Document No: 20101104
Page 3 and 4: Installation process for upgrade ki
Page 5 and 6: 7. Unscrew the screws on the transf
Page 7 and 8: 12. Cut the cable ties that tighten
Page 9 and 10: 18. Unscrew the four screws on the
Page 11 and 12: 25. Place the new electric control
Page 13 and 14: -- Page 13 of 38 --- 30. Place the
Page 15 and 16: Installation process for upgrade ki
Page 17 and 18: 7. Unscrew the screws on the transf
Page 21 and 22: 19. Unscrew the nine screws on the
Page 23 and 24: 26. Install the new electric contro
Page 25 and 26: 32. Plug the power cord assembly co
Page 27: Installation process for upgrade ki
Page 33 and 34: 19. Unscrew the nine screws on the
Page 35 and 36: 26. Install the new electric contro
Page 37 and 38: 32. Plug the power cord assembly co

Service Bulletin

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?