Service Bulletin
Service Bulletin
Service Bulletin
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
27. Before positioning the new motor side cover, put the new quick connector board<br />
(with two male quick connectors) through the hole.<br />
New motor<br />
side cover<br />
Hole in the<br />
motor side<br />
cover<br />
Figure 39<br />
28.Tighten the 8 Phillips pan head machine screws M6×10 (1/2SS-3C-042).<br />
Figure 40<br />
29. Place the new quick connector board on the motor side cover. Make sure to orient it<br />
properly with the 4P male connector on the left. Tighten the 6 Phillips pan head machine<br />
screws M5×10.<br />
Phillips pan head<br />
machine screws<br />
M5×10<br />
Figure 41<br />
12<br />
New quick connector board<br />
(with two male quick<br />
connectors)<br />
Phillips pan head<br />
machine screws<br />
M6×10<br />
-- Page 12 of 38 ---
Change language