Service Bulletin

More documents

Recommendations

Info

New Wiring Diagram: Single Phase Only 14 -- Page 14 of 38 ---
Installation process for upgrade kit For 3 Phase 1 Speed Electric Hoist (1/2 Ton—5Ton) 1. Confirm that the electric hoist is disconnected from the power supply. 2. Unscrew the 8 Phillips pan head machine screws M6×10 (1/2SS-3C-042) from the motor side cover (1/2SS-3C-102 or 1SS-3C-102). motor side cover (1/2SS-3C- 102 or 1SS-3C-102 ) Figure 1 Figure 2 3. Move the motor side cover (1/2SS-3C-102 or 1SS-3C-102) away from the hoist body. motor side cover (1/2SS-3C- 102 or 1/2SS-3C-102 ) Phillips pan head machine screw M6×10 (1/2SS-3C-042) Figure 3 Figure 4 15 -- Page 15 of 38 ---
Page 1 and 2: Issued by: GS Document No: 20101104
Page 3 and 4: Installation process for upgrade ki
Page 5 and 6: 7. Unscrew the screws on the transf
Page 7 and 8: 12. Cut the cable ties that tighten
Page 9 and 10: 18. Unscrew the four screws on the
Page 11 and 12: 25. Place the new electric control
Page 13: -- Page 13 of 38 --- 30. Place the
Page 17 and 18: 7. Unscrew the screws on the transf
Page 21 and 22: 19. Unscrew the nine screws on the
Page 23 and 24: 26. Install the new electric contro
Page 25 and 26: 32. Plug the power cord assembly co
Page 27 and 28: Installation process for upgrade ki
Page 29 and 30: -- Page 29 of 38 --- 7. Unscrew the
Page 33 and 34: 19. Unscrew the nine screws on the
Page 35 and 36: 26. Install the new electric contro
Page 37 and 38: 32. Plug the power cord assembly co

Service Bulletin

Create successful ePaper yourself

Delete template?

Save as template?