MODEM ROUTER USER MANUAL - Warranty Life

Idle Time (ms) “Idle Time” is set to stop the connection when the
network traffic is not sending or receiving after an idle
time.
Type Fixed IP – Set the static IP Address to the router. Enter
the IP address your ISP has assigned.
DHCP – To get the IP address from the ISP directly.
Local IP Address Set the IP address obtained from your ISP.
Remote IP Address Enter the remote IP address assigned by your ISP.
Subnet Mask Enter the subnet mask assigned by your ISP.
Unnumbered The IP Unnumbered configuration allows you to enable
IP processing on a serial interface without assigning it an
explicit IP address. When it is enabled, the router’s WAN
IP address can “borrow” the IP address of another
interface already configured on the router, which
conserves network and address space. Check it if you
want to assign the WAN IP address from other interface,
such as a client’s IP address.
Default Route When “Default Router” is enabled, all the packets for
destinations not known by the router’s routing table are
sent to the default route. By default, it is enabled.
Add/Modify These buttons are for you to maintain the channel
configuration settings.
Current ATM VC Table The channel you have configured will be listed here. You
can select the VC channel to Edit or Delete.
Delete Selected If you want to delete a specific VC channel entry, check
Enable Auto-PVC
Search
the “select” box of the VC channel you want to delete,
then click “Delete Selected.”
Check the box and click “Apply” to enable the auto PVC
search function.
VPI VPI is a virtual path that determines the way an ATM cell
should be routed.
VCI VCI is the label given to an ATM VC to identify it and
determine its destination.
Add/Delete These buttons are for you to maintain the Current Auto-
PVC Table.
33