MODEM ROUTER USER MANUAL - Warranty Life

More documents

Recommendations

Info

or eight numeric digits. If users enter an eight-digit PIN with checksum error, a warning message pops up. If users insist on this PIN, the router will take it. When you finish, click “Apply Changes.” You’ll see the following message displayed on Web browser. Click “Continue” to save the settings made and go back to the Web management interface; click “Apply” to save the settings made and restart the router so the settings will take effect after it reboots. 5.2.5 QoS The router supports the IP QoS feature, which can provide different priorities to different users or data flows. 58
Parameter Description IP QoS Click the radio button to enable or disable the function. Default QoS Select the default mode of QoS from the menu. • IP Precedence: In QoS, a three-bit field in the ToS byte of the IP header (see RFC 791). Using IP Precedence, a network administrator can assign values from 0 (the default) to 7 to classify and prioritize types of traffic. • 802.1P: IEEE 802.1p is a three-bit field within an Ethernet frame header when using tagged frames on an 802.1 network. It specifies a priority value between 0 and 7 inclusive that can be used by Quality of Service (QoS) disciplines to differentiate traffic. Source IP The IP address of the traffic source. Source Netmask The source IP netmask. This field is required if the source IP has been entered. Source Port The source port of the selected protocol. You cannot configure this field without entering the protocol first. Destination IP The IP address of the traffic destination. Destination Netmask The destination IP netmask. This field is required if the destination IP has been entered. Destination Port The destination port of the selected protocol. You cannot configure this field without entering the protocol first. Protocol The selections are TCP, UDP, ICMP and blank for none. This field is required if the source port or destination port has been entered. Physical Port The incoming ports. The selections include LAN ports, wireless port and blank for not applicable. Outbound Priority The priority level for the traffic that matches this classification rule. The possible selections are (in the descending priority): p0, p1, p2, p3. 802.1p Select this field to mark the three-bit user-priority field in the 802.1p header of the packet that matches this classification rule. Note that this 802.1p marking is workable on a given PVC channel only if the VLAN tag is enabled in this PVC channel. 59
Page 1 and 2:
WIRELESS 300N ADSL2+ MODEM ROUTER U
Page 3 and 4:
FCC Part 15 This equipment has been
Page 5 and 6:
Contents 1 INTRODUCTION............
Page 7 and 8:
1 Introduction Thank you for purcha
Page 9 and 10:
2 Hardware Rear Panel Item Name Des
Page 11 and 12:
Installation 1. Connect the router
Page 13 and 14: 3. The wizard will run and try to s
Page 15 and 16: 3.2 Automatically Set the ISP If yo
Page 17 and 18: 5. The wizard will try to connect t
Page 19 and 20: 2. Check with your ISP as to the co
Page 21 and 22: outer automatically. NOTE 1: To use
Page 23 and 24: 4 IP Address Setting To use the rou
Page 25 and 26: 5. Click “OK” to confirm the se
Page 27 and 28: 5 Web Management Configuration Once
Page 29 and 30: 5.1 Quick Setup The Quick Setup sec
Page 31 and 32: 5.2 General Setup Start your Web br
Page 33 and 34: If you see the following message: I
Page 35 and 36: Click “Continue” to save the se
Page 37 and 38: PPPoE VPI/VCI, VC-based/LLC-based m
Page 39 and 40: Idle Time (ms) “Idle Time” is s
Page 41 and 42: is included in the header of an ATM
Page 43 and 44: carry any data. Click “Tone Mask
Page 45 and 46: Parameter Description Enable Check
Page 47 and 48: RIP Config Table The RIP you have c
Page 49 and 50: 5.2.3.1 DHCP Mode You can configure
Page 51 and 52: Parameter Description LAN IP Addres
Page 53 and 54: When you finish, click “Apply Cha
Page 55 and 56: Control Sideband Select the upper b
Page 57 and 58: Fragmentation Threshold • Auto is
Page 59 and 60: 5.2.4.3 Security This router provid
Page 61 and 62: RADIUS Server password of the exter
Page 63: Parameter Description Disable WPS C
Page 67 and 68: 5.2.6.1 Port Forwarding Port Forwar
Page 69 and 70: Parameter Description Disabled/Enab
Page 71 and 72: 5.2.6.4 IGMP Proxy When IGMP Proxy
Page 73 and 74: listed in the table from connecting
Page 75 and 76: Source MAC Address This must be in
Page 77 and 78: When you finish, click “Apply Cha
Page 79 and 80: Destination The destination can be
Page 81 and 82: Click “Continue” to save the se
Page 83 and 84: 5.3.1 Interface You can view statis
Page 85 and 86: 5.4 Tools The Tools section include
Page 87 and 88: 5.4.4 ATM Loopback In order to isol
Page 89 and 90: 6 Troubleshooting The LAN LED on th
Page 91 and 92: I forget my login username and/or p
Page 93 and 94: 7 Glossary 10Base-T It is an Ethern
Page 95 and 96: MAC Address MAC stands for media ac
Page 97 and 98: Router A system responsible for mak
Page 99 and 100: - URL filter • Supports UPnP (Uni
Page 101 and 102: WASTE ELECTRICAL & ELECTRONIC EQUIP
Page 103 and 104: WARRANTY INFORMATION ENGLISH: For w
show all

MODEM ROUTER USER MANUAL - Warranty Life

Create successful ePaper yourself

Delete template?

Save as template?