MODEM ROUTER USER MANUAL - Warranty Life

More documents

Recommendations

Info

Click “Continue” to save the settings made and go back to the Web management interface; click “Apply” to save the settings made and restart the router so the settings will take effect after it reboots. 5.2.6.3 UPNP When the UPnP function is enabled, the router can be detected by UPnP- compliant systems such as Windows XP. The router will be displayed in the Neighborhood of Windows XP, so you can directly double-click the router or right- click the router and select “Invoke” to configure the router through a Web browser. Parameter Description UPnP Enable or disable the UPnP feature. WAN Interface The upstream WAN interface is selected here. Select a WAN interface that will use UPnP from the drop-down menu. When you finish, click “Apply Changes.” You’ll see the following message displayed on Web browser. Click “Continue” to save the settings made and go back to the Web management interface; click “Apply” to save the settings made and restart the router so the settings will take effect after it reboots. 64
5.2.6.4 IGMP Proxy When IGMP Proxy (Internet Group Management Protocol Proxy) is enabled, the router can make intelligent multicast forwarding decisions by examining the contents of each frame’s IP header. Without the function, the router will broadcast the multicast packets to each port and may create excessive traffic on the network and degrade the performance of the network. The IGMP Proxy screen allows you to enable multicast on WAN and LAN interfaces. The LAN interface always serves as a downstream IGMP proxy, and you can configure one of the available WAN interfaces as the upstream IGMP proxy. Upstream is the interface used when IGMP requests from hosts are sent to the multicast router. Downstream is the interface used when data from the multicast router are sent to hosts in the multicast group database. Parameter Description IGMP Proxy Enable or disable the IGMP proxy feature. Proxy Interface The upstream WAN interface is selected here. When you finish, click “Apply Changes.” You’ll see the following message displayed on Web browser. 65
Page 1 and 2:
WIRELESS 300N ADSL2+ MODEM ROUTER U
Page 3 and 4:
FCC Part 15 This equipment has been
Page 5 and 6:
Contents 1 INTRODUCTION............
Page 7 and 8:
1 Introduction Thank you for purcha
Page 9 and 10:
2 Hardware Rear Panel Item Name Des
Page 11 and 12:
Installation 1. Connect the router
Page 13 and 14:
3. The wizard will run and try to s
Page 15 and 16:
3.2 Automatically Set the ISP If yo
Page 17 and 18:
5. The wizard will try to connect t
Page 19 and 20: 2. Check with your ISP as to the co
Page 21 and 22: outer automatically. NOTE 1: To use
Page 23 and 24: 4 IP Address Setting To use the rou
Page 25 and 26: 5. Click “OK” to confirm the se
Page 27 and 28: 5 Web Management Configuration Once
Page 29 and 30: 5.1 Quick Setup The Quick Setup sec
Page 31 and 32: 5.2 General Setup Start your Web br
Page 33 and 34: If you see the following message: I
Page 35 and 36: Click “Continue” to save the se
Page 37 and 38: PPPoE VPI/VCI, VC-based/LLC-based m
Page 39 and 40: Idle Time (ms) “Idle Time” is s
Page 41 and 42: is included in the header of an ATM
Page 43 and 44: carry any data. Click “Tone Mask
Page 45 and 46: Parameter Description Enable Check
Page 47 and 48: RIP Config Table The RIP you have c
Page 49 and 50: 5.2.3.1 DHCP Mode You can configure
Page 51 and 52: Parameter Description LAN IP Addres
Page 53 and 54: When you finish, click “Apply Cha
Page 55 and 56: Control Sideband Select the upper b
Page 57 and 58: Fragmentation Threshold • Auto is
Page 59 and 60: 5.2.4.3 Security This router provid
Page 61 and 62: RADIUS Server password of the exter
Page 63 and 64: Parameter Description Disable WPS C
Page 65 and 66: Parameter Description IP QoS Click
Page 67 and 68: 5.2.6.1 Port Forwarding Port Forwar
Page 69: Parameter Description Disabled/Enab
Page 73 and 74: listed in the table from connecting
Page 75 and 76: Source MAC Address This must be in
Page 77 and 78: When you finish, click “Apply Cha
Page 79 and 80: Destination The destination can be
Page 81 and 82: Click “Continue” to save the se
Page 83 and 84: 5.3.1 Interface You can view statis
Page 85 and 86: 5.4 Tools The Tools section include
Page 87 and 88: 5.4.4 ATM Loopback In order to isol
Page 89 and 90: 6 Troubleshooting The LAN LED on th
Page 91 and 92: I forget my login username and/or p
Page 93 and 94: 7 Glossary 10Base-T It is an Ethern
Page 95 and 96: MAC Address MAC stands for media ac
Page 97 and 98: Router A system responsible for mak
Page 99 and 100: - URL filter • Supports UPnP (Uni
Page 101 and 102: WASTE ELECTRICAL & ELECTRONIC EQUIP
Page 103 and 104: WARRANTY INFORMATION ENGLISH: For w
show all

MODEM ROUTER USER MANUAL - Warranty Life

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?