MODEM ROUTER USER MANUAL - Warranty Life

More documents

Recommendations

Info

Use 802.1x Authentication WPA2 (AES) for data encryption. The actual selection of the encryption methods will depend on the clients. IEEE 802.1x is an authentication protocol. Every user must use a valid account to log in to this wireless router before accessing the wireless LAN. The authentication is processed by a RADIUS server. Check this box to authenticate a user by IEEE 802.1x. WEP-64Bits WEP is a lower level of security than WPA, and supports 64-bit and 128-bit key lengths to encrypt the wireless data. The longer key length will provide higher security. When “WEP-64Bits” is selected, you need to enter exactly 5 ASCII characters (“a-z” and “0-9”) or 10 hexadecimal digits (“0-9,” “a-f”) for each Key (1-4). WEP-128Bits When “WEP-128Bits” is selected, you need to enter WPA Authentication Mode Pre-Shared Key Format exactly 13 ASCII characters (“a-z” and “0-9”) or 26 hexadecimal digits (“0-9,” “a-f”) for each Key (1-4). There are two types of authentication mode for WPA. • Enterprise (RADIUS) uses an external RADIUS server to perform user authentication. To use RADIUS, enter the IP address of the RADIUS server, the RADIUS port (default is 1812) and the shared secret from the RADIUS server. Refer to the “Authentication RADIUS Server” setting below for RADIUS setting. • Personal (Pre-Shared Key) authentication is based on a shared secret that is known only by the parties involved. To use WPA Pre-Shared Key, select the key format and enter a password in the “Pre-Shared Key Format” and “Pre-Shared Key” settings. You can select Passphrase (alphanumeric format) or Hexadecimal Digits (in the “A-F,” “a-f” and “0-9” range) to be the Pre-shared Key. For example: Passphrase: ”iamguest” Hexadecimal Digits: “12345abcde” Pre-Shared Key Enter 8-63 characters as the “Pre-Shared Key.” Authentication Enter the port (default is 1812), the IP address and the 54
RADIUS Server password of the external RADIUS server. When you finish, click “Apply Changes.” You’ll see the following message displayed on Web browser. Click “Continue” to save the settings made and go back to the Web management interface; click “Apply” to save the settings made and restart the router so the settings will take effect after it reboots. 5.2.4.4 Access Control This wireless router provides MAC Address Control, which prevents unauthorized MAC addresses from accessing your wireless network. Parameter Description Wireless Access Control Mode This router can prevent wireless clients from accessing the wireless network by checking the MAC address of the 55
Page 1 and 2:
WIRELESS 300N ADSL2+ MODEM ROUTER U
Page 3 and 4:
FCC Part 15 This equipment has been
Page 5 and 6:
Contents 1 INTRODUCTION............
Page 7 and 8:
1 Introduction Thank you for purcha
Page 9 and 10: 2 Hardware Rear Panel Item Name Des
Page 11 and 12: Installation 1. Connect the router
Page 13 and 14: 3. The wizard will run and try to s
Page 15 and 16: 3.2 Automatically Set the ISP If yo
Page 17 and 18: 5. The wizard will try to connect t
Page 19 and 20: 2. Check with your ISP as to the co
Page 21 and 22: outer automatically. NOTE 1: To use
Page 23 and 24: 4 IP Address Setting To use the rou
Page 25 and 26: 5. Click “OK” to confirm the se
Page 27 and 28: 5 Web Management Configuration Once
Page 29 and 30: 5.1 Quick Setup The Quick Setup sec
Page 31 and 32: 5.2 General Setup Start your Web br
Page 33 and 34: If you see the following message: I
Page 35 and 36: Click “Continue” to save the se
Page 37 and 38: PPPoE VPI/VCI, VC-based/LLC-based m
Page 39 and 40: Idle Time (ms) “Idle Time” is s
Page 41 and 42: is included in the header of an ATM
Page 43 and 44: carry any data. Click “Tone Mask
Page 45 and 46: Parameter Description Enable Check
Page 47 and 48: RIP Config Table The RIP you have c
Page 49 and 50: 5.2.3.1 DHCP Mode You can configure
Page 51 and 52: Parameter Description LAN IP Addres
Page 53 and 54: When you finish, click “Apply Cha
Page 55 and 56: Control Sideband Select the upper b
Page 57 and 58: Fragmentation Threshold • Auto is
Page 59: 5.2.4.3 Security This router provid
Page 63 and 64: Parameter Description Disable WPS C
Page 65 and 66: Parameter Description IP QoS Click
Page 67 and 68: 5.2.6.1 Port Forwarding Port Forwar
Page 69 and 70: Parameter Description Disabled/Enab
Page 71 and 72: 5.2.6.4 IGMP Proxy When IGMP Proxy
Page 73 and 74: listed in the table from connecting
Page 75 and 76: Source MAC Address This must be in
Page 77 and 78: When you finish, click “Apply Cha
Page 79 and 80: Destination The destination can be
Page 81 and 82: Click “Continue” to save the se
Page 83 and 84: 5.3.1 Interface You can view statis
Page 85 and 86: 5.4 Tools The Tools section include
Page 87 and 88: 5.4.4 ATM Loopback In order to isol
Page 89 and 90: 6 Troubleshooting The LAN LED on th
Page 91 and 92: I forget my login username and/or p
Page 93 and 94: 7 Glossary 10Base-T It is an Ethern
Page 95 and 96: MAC Address MAC stands for media ac
Page 97 and 98: Router A system responsible for mak
Page 99 and 100: - URL filter • Supports UPnP (Uni
Page 101 and 102: WASTE ELECTRICAL & ELECTRONIC EQUIP
Page 103 and 104: WARRANTY INFORMATION ENGLISH: For w
show all

MODEM ROUTER USER MANUAL - Warranty Life

Create successful ePaper yourself

Delete template?

Save as template?