DF500 Folder Operator Guide - Pitney Bowes Canada
DF500 Folder Operator Guide - Pitney Bowes Canada
DF500 Folder Operator Guide - Pitney Bowes Canada
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>DF500</strong> <strong>Folder</strong> <strong>Operator</strong> <strong>Guide</strong><br />
MOVING THE <strong>DF500</strong><br />
1. If moving the <strong>DF500</strong>, make sure that it is unplugged and that<br />
it is placed on an ap pro pri ate work surface. There has to be<br />
a min i mum clear ance of 36" (914mm) on three sides of the<br />
machine for op er a tor access. Rec om mend ed table height is<br />
30" (762mm).<br />
2. Lift the <strong>DF500</strong> from under each end. Do not lift the unit using<br />
the paper support guides, control panel, or fold plate door.<br />
AC Input for<br />
Power Cord<br />
WARNING: To avoid personal injury or damage<br />
to the machine, two people should be used to<br />
lift the <strong>DF500</strong>.<br />
WARNING: To avoid personal injury or damage to<br />
the machine, make sure you lift the folder by the<br />
bottom of the chassis. Do not use the fold plate<br />
compartment door on the side as a handle, as it<br />
will open up and cause you to drop the machine.<br />
3. Install the line cord into the AC input on the side of the<br />
<strong>DF500</strong> (see below) and then plug it in to a grounded 115<br />
VAC outlet.<br />
Power Switch<br />
4. Turn the machine on and verify that the control panel displays<br />
the power-up screen (see below).<br />
JOB: 1 READY<br />
ØØØØØØ<br />
8 SV40214 Rev. A
Change language