DF500 Folder Operator Guide - Pitney Bowes Canada

DF500 Folder Operator Guide
AUTOMATIC FOLD SETUP
Selecting Paper Size
1. Press the Paper key to select the desired paper size length.
Each press of the key will step through the three standard
paper sizes and “other” and will light the appropriate paper
size indicator on the control panel.
2. At the same time, the display will show the selected paper
length in millimeters. For example:
T1 PAPER = 297.Ø
CHG: DONE: Enter
3. If your paper isn’t a standard size, press the or key, to
change the size. Each key press will change the paper size by
about 1/64" (0.5mm). Holding the key down for more than
one second will increase the step size, allowing large changes
to be made rapidly.
4. When the correct paper size is shown, proceed with “Selecting
Fold Type” below. NOTE: The DF500’s electronic control
system will not allow you to deviate too far from the standard
settings. This will prevent jams caused by “impossible” folds.
Selecting Fold Type
Before selecting a fold, make sure you have already set the
DF500 to the correct paper size length. This will prevent the machine
from setting up a fold for the wrong paper length, which
could result in a paper jam.
1. Press the Fold Type key to select one of the six pre-programmed
fold types. Each key press will turn on the indicator
associated with each fold type.
2. When you have made your selection, press the Enter key. The
display will show:
TEMP JOB: 1 READY
ØØØØØØ
3. While the machine is setting up the fold, all keys on the control
panel are disabled and will not respond if pressed.
(continued on next page)
12 SV40214 Rev. A