DF500 Folder Operator Guide - Pitney Bowes Canada
DF500 Folder Operator Guide - Pitney Bowes Canada
DF500 Folder Operator Guide - Pitney Bowes Canada
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>DF500</strong> <strong>Folder</strong> <strong>Operator</strong> <strong>Guide</strong><br />
Error Messages Displayed on the Control Panel (continued)<br />
Error Message What It Means <strong>Operator</strong> Action<br />
Jam In <strong>Folder</strong><br />
Open Top Cover<br />
Jam In Stacker<br />
Done Enter<br />
Limit Switch F.P.1<br />
Or<br />
Limit Switch F.P.2<br />
Motor Stopped<br />
Open Top Cover<br />
Programs Full<br />
Clear Job First<br />
A paper jam has occurred<br />
within the machine.<br />
A folded sheet has not<br />
been ejected properly<br />
onto the stacker table. It<br />
is usually caused by paper<br />
piling up when the stacker<br />
table is full or by a double<br />
sheet. In rare cases, with<br />
certain types of paper,<br />
it can also happen when<br />
a folded sheet catches<br />
the topmost panel of the<br />
preceding sheet. The<br />
sheet causing the jam will<br />
probably look like this: Z<br />
or like this: Z<br />
The stop in either fold<br />
plate 1 (F.P.1) or fold plate<br />
2 (F.P.2) has moved to<br />
the very end of its travel<br />
and has operated the<br />
emergency limit switches<br />
at those positions.<br />
A large paper jam caused<br />
the motor to stall. The<br />
internal electronic control<br />
in the <strong>DF500</strong> will shut<br />
down the motor and<br />
display this message.<br />
You have attempted to<br />
save a new job but all nine<br />
memory locations are<br />
already full.<br />
Refer to “Clearing a jam”<br />
on page 32 and “Removing<br />
the fold plates” on page<br />
33.<br />
• Remove all paper from<br />
the stacker table,<br />
then press Enter. The<br />
stacker wheels will<br />
return to their operating<br />
position and the display<br />
will show operating<br />
mode again.<br />
• Open the top cover<br />
and remove any paper<br />
inside. Close the top<br />
cover and press Enter<br />
to clear the display<br />
message.<br />
• If possible, adjust the<br />
fold to look more even<br />
like this: Z<br />
Follow the procedure for<br />
“FOLD PLATE ERROR”<br />
above to clear this<br />
condition.<br />
Refer to “Clearing a jam”<br />
on page 32 and “Removing<br />
the fold plates” on page<br />
33.<br />
Delete some jobs to make<br />
room (see page 27).<br />
38 SV40214 Rev. A