appendix 1 - Victor Technologies

More documents

Recommendations

Info

APPENDIX 6: PILOT/OUTPUT PC BOARD LAYOUT AND WIRING CONNECTION DIAGRAM D5 TP4 TP5 TP8 TP2 TP6 TP3 TP1 Pilot Output PC Board Signals Pilot/Output PC Board J13 TP7 J12 J12-1 Torch Switch from J22-3 Torch Control J12-2 Shield to J22-1 J12-3 Torch Switch from J22-4 Torch Control J12-4 Shield to J22-2 J12-5 Not Used J12-6 Not Used J12-7 OK-To-Move To J22-12 (Isolated Contacts from Logic PC Board) J12-8 OK-To-Move To J22-14 (Isolated Contacts from Logic PC Board) J12-9 Enable Jumper J12-10 Not Used J12-11 Enable Jumper J12-12 Not Used J12-13 Not Used J12-14 Return to J22-8 J12-15 Not Used J12-16 Not Used APPENDIX A-8 Manual 0-2697 A-02311
J13-1 Active Low Start signal (Torch Switch) J13-2 Torch Switch Return J13-3 OK-To-Move (Isolated Contacts from Logic PC Board) J13-4 OK-To-Move (Isolated Contacts from Logic PC Board) J13-5 Ground J13-6 Not Used J13-7 Drag Voltage Sensing (Tip Voltage) J13-8 Not Used J13-9 PS(-) Voltage Sensing J13-10 Not Used J13-11 Enable Jumper J13-12 Enable Jumper J13-13 Not Used J13-14 36 VAC (a) from Logic PC Board J13-15 36 VAC (b) from Logic PC Board J13-16 36 VAC CT Common J13-17 Return for Pilot Signal J13-18 Active Low Pilot Signal J13-19 Not Used J13-20 Active Low Overtemp Signal J13-21 Return for Overtemp Signal J13-22 Active Low CSR Sense Signal J98-1 J13-23 Return for CSR Sense Signal J98-2 J13-24 +12 vdc to Current Sense Board J98-3 Twisted 3-Wire Harness From Current Sensor PCB A-02558 J13 TP1 Ground TP2 +15 vdc TP3 Pilot Switch to Gate Drive PC Board TP4 Pilot Drive Signal TP5 Not Used TP6 Active Low Pilot Drive Signal TP7 Not Used TP8 Pilot Switch to Gate Drive PC Board D5 Pilot ON Indicator Wire #13 To Resistors Jumper Wire Jumper Wire Manual 0-2697 A-9 APPENDIX J12 Stiff CD Coil Wire Output Inductor Lead Output Inductor Lead Wire #17 (Black) Wrapped Around Wire #15 4-Wires #12 (Red) From FET/Heatsink Assemblies Wire From Transformer Wire #14 To Resistors Ground (Green) Wire Wire #15 (Red) From Bulkhead Wire From Transformer Wire #17 (Black) Wrapped Around Wire #15 Work Cable
Page 1:
PLASMA CUTTING POWER SUPPLY PAK Mas
Page 4 and 5:
TABLE OF CONTENTS SECTION 1: GENERA
Page 7 and 8:
SECTION 1: GENERAL INFORMATION 1.01
Page 9 and 10:
6. ANSI Standard Z49.2, FIRE PREVEN
Page 11 and 12:
ultra-violets très forts. Ces rayo
Page 13 and 14:
1.07 Declaration of Conformity Manu
Page 15 and 16:
SECTION 2: INTRODUCTION 2.01 Scope
Page 17 and 18:
SECTION 3: DESCRIPTION 3.01 Scope o
Page 19 and 20:
15. Weight Power Supply with Torch:
Page 21 and 22:
4.01 Introduction SECTION 4: SERVIC
Page 23 and 24:
The Logic PC Board controls the tim
Page 25 and 26: cut being more square than the othe
Page 27 and 28: Set the Power Supply RUN/SET switch
Page 29 and 30: 4. Clogged coolant filter and/or in
Page 31 and 32: a. Check continuity per appropriate
Page 33 and 34: NOTE Art may differ from actual uni
Page 35 and 36: H. Temperature Circuit Test The Pow
Page 37 and 38: ange, check between the two output
Page 39 and 40: SECTION 5: REPLACEMENT PROCEDURES 5
Page 41 and 42: C. Work Cable Replacement 1. Remove
Page 43 and 44: 5.06 Left Side Center Chassis Parts
Page 45 and 46: I. FET/Heatsink Assembly Replacemen
Page 47 and 48: G. Coolant Reservoir Replacement CA
Page 49 and 50: 9. Carefully slide the rear panel o
Page 51 and 52: M. Current Sense PC Board Assembly
Page 53 and 54: E. Motor (M5) / Fan / Pump Replacem
Page 55 and 56: 7. Remove rear panel from unit by c
Page 57 and 58: 6.01 Introduction SECTION 6: PARTS
Page 59 and 60: 6.04 Access Panel Replacement Parts
Page 61 and 62: 3 2 4 6 10 9 9 1 Manual 0-2697 6-5
Page 63 and 64: 12 1 5 4 3 17 10 11 21 10 Manual 0-
Page 65 and 66: 9 A-02278 3 11 10 20 6 5 23x4274 Ma
Page 67 and 68: 11 10 4 15 5 9 11 6 10 4 15 5 9 A-0
Page 69 and 70: APPENDIX 1: INPUT WIRING REQUIREMEN
Page 71 and 72: Pot/LED PC Board Signals APPENDIX 3
Page 73 and 74: J3-10 +12 vdc J3-11 Active Low Sign
Page 75: J9-1 36 VAC (b) from Logic PC Board
Page 79 and 80: E1 E2 E7 E8 Component Side of PC Bo
Page 81 and 82: FET PC Board Signals (Upper and Low
Page 83 and 84: APPENDIX 11: CURRENT SENSOR PC BOAR
Page 85 and 86: APPENDIX 13: RECOMMENDED ROUTINE MA
Page 87 and 88: NOTE Transformer T3 in earlier prod
Page 89 and 90: NOTE Transformer T3 in earlier prod
Page 91: Art # A-04328
show all

appendix 1 - Victor Technologies

Create successful ePaper yourself

Delete template?

Save as template?