Therma-Tru Slim-Line Sliding Patio Door Assembly and Installation

More documents

Recommendations

Info

24Weatherproof, Finish and Maintain System Caulk around entire system on exterior side. Seal sealing fins to siding or facing, seal front bottom edge of sill, seal all joints between jambs and moldings. Seal joints between exterior hardware trim and door face to prevent air and water infiltration. ® Paint or stain according to Therma-Tru instructions. Do NOT paint gaskets or weatherstrip. Maintain or replace sealants and finishes as soon as any deterioration is evident. For semigloss, glossy paints, or clear coats, do this when surface becomes dull or rough. More severe exposures require more frequent maintenance. Use the touch up paint to paint the heads of the rough opening screws. 23
Transom Transom ® The following packages are needed to complete the installation of your Therma-Tru Slim-Line Sliding Patio Door Transom. Check all components for correct size and color. See page 42 for sizing information. Tools and materials needed for assembly and installation: 100% Silicone Sealant and Caulk Gun 1' Level Measuring Tape Electric Drill #2 Phillips Drive Bit Staple Gun or Brad Nails 1/8“ Drill Bit Flat-blade Screwdriver Gloves Safety Glasses Partial Roll of Insulation Shims Saw 24
Page 1 and 2: Therma-Tru Slim-Line Sliding Patio
Page 3 and 4: ® The following packages are neede
Page 5 and 6: 3 ATTACH HEAD TO JAMBS 4 DRIP CAP I
Page 7 and 8: 5 4 APPLY SILICONE SEALANT TO BOTTO
Page 9 and 10: 9 10 PLUMB SIDE JAMBS Jambs must be
Page 11 and 12: 13 15 INSTALL ANCHOR TO THE INACTIV
Page 13 and 14: 19 20 ATTACH ACTIVE WEATHERSTRIP CA
Page 15 and 16: 24 25 INSTALL KEEPER Align keeper t
Page 17 and 18: 28 29 SLIDING SCREEN DOOR Refer to
Page 19 and 20: 1A 2A Assembly NOTE: A large work a
Page 21 and 22: 5A APPLY SEALANT TO SILL Apply a co
Page 23: 10A 11A ATTACH M.E.U. TO TWO PANEL
Page 27 and 28: 4B ATTACH TRANSOM TO PATIO UNIT A.
Page 29 and 30: 6B INDEPENDENT INSTALLATION Turn to
Page 31 and 32: 1C FRAME ASSEMBLY Proceed to page 3
Page 33 and 34: 7C INSERT PANEL BUMPER Insert panel
Page 35 and 36: 1D FRAME ASSEMBLY STEPS 1 -11 Proce
Page 37 and 38: 7D PASSIVE HANDLE INSTALL A. Assemb
Page 39 and 40: A B JAMB EXTENSION INFORMATION The
Page 41 and 42: D TRIPLE SYSTEM INFORMATION The int
Page 43 and 44: R.H. = Replacement Height SL = Side
Page 45: 1687 Woodlands Dr. Maumee, OH 43537

Therma-Tru Slim-Line Sliding Patio Door Assembly and Installation

Create successful ePaper yourself

Delete template?

Save as template?