U 100-C - Astro

More documents

Recommendations

Info

12 Controller restart / Reset To restart the controller or to reset it to the factory default settings, you must switch to the corresponding sub-menu using the link “Restart/reset” on the left edge of the web interface. The following input mask appears: Figure 44: Input mask for controller restart/reset Selecting “Restart” will reboot the device, while retaining all settings. Selecting “Soft reset” deletes the current configuration of the U 100-C. The network settings and user accounts will be retained. Selecting “Hard reset” restores the delivery state, i.e. the U 100-C configuration, the network settings and user accounts will be deleted. Note: Selecting “Hard reset” may lead to the headend being unreachable by remote access. 32 Operating Manual U 100-C Controller
13 Technical data Type U 100-C Order number 380 103 Network interfaces (forwarded passively to U 1xx) Protocol IEEE802.3 Ethernet, RTP, ARP, IPv4, TCP/UDP, HTTP, SNTP, IGMPv3 General data Power consumption [W] 27 Housing 19", 1 HE Permitted ambient temperature [°C] 0...+45 Operating Manual U 110-C Controller 33
Page 1 and 2: Operating instructions U 100-C Cont
Page 3 and 4: Table of contents 1 Figures .......
Page 5 and 6: 2 Introduction The instructions in
Page 7 and 8: 2.8 Installing and coding the backp
Page 9 and 10: 3 General introduction 3.1 Connecti
Page 11 and 12: Figure 7: Example view of the “Ne
Page 13 and 14: A new user is set up in the first b
Page 15 and 16: 3.8 Adding U 1xx signal converters
Page 17 and 18: 4.2 Output channel overview / Chann
Page 19 and 20: 5.2 Saving and deleting the system
Page 21 and 22: To write stored module settings int
Page 23 and 24: 7 Switching equivalent head-end mod
Page 25 and 26: The U 100-C controller provides the
Page 27 and 28: The settings in the “SNMP System
Page 29 and 30: 9.4 Updating U 1xx headend modules
Page 31: Figure 42: Setting up a time-contro
Page 35 and 36: Operating Manual U 110-C Controller

U 100-C - Astro

Create successful ePaper yourself

Delete template?

Save as template?