HP Server Migration Pack – Universal Edition User Guide - Index of

Configure the storage on this server to accommodate the data to be migrated from the source
server.
3. (Optional) This step only applies to physical servers. To configure or reconfigure the HP array
controllers, click Launch Array Configuration Utility. The Array Configuration Utility appears in a
new window. The server automatically reboots after exiting the Array Configuration Utility,
regardless of whether changes were made. For virtual servers, the Launch Array Configuration
Utility button does not appear.
4. To proceed with network configuration, click Next.
NOTE: To eject the SMP Universal Boot CD and reboot the destination server, click Abort Migration
and Reboot.
5. You can only configure one IP address for the destination server. Ensure that the selected
network card can connect to the same network as the application station. Configure the network
to enable the SMP Universal Agent by selecting the adapter from the list. Select one of the
following:
○ Dynamically obtain an IP address from a DHCP server—This is the default option. The list and
text boxes are disabled when DHCP (Dynamic Host Configuration Protocol) is selected.
○ Configure a Static IP Address—The list displays all available network cards for this system.
The Select adapter, IP Address (must be unique), and Subnet mask entries are required.
Specifying the gateway information is optional. The Next button is disabled until the required
entries are entered, or if an invalid value for the IP address, subnet mask, or gateway is entered.
Deploying SMP Universal Agents 32