Download - Flir Systems
Download - Flir Systems
Download - Flir Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
System Startup<br />
Troubleshooting Tip: if the JCU does not have power, it may be connected<br />
to a Power over Ethernet (PoE) switch which has not been powered on, or it<br />
may be connected to a network switch that does not provide PoE power.<br />
Bootup Mode<br />
The following section describes what happens when the circuit breaker is<br />
energized and power is applied to the camera. The camera will stay in the<br />
Bootup state for approximately 55 seconds. During the bootup process,<br />
the bootup screen and messages are displayed on the monitor, followed by<br />
live video, which is displayed only momentarily, until the camera goes into<br />
standyby mode..<br />
Initially the FLIR splash screen will appear, as shown to the left. Then<br />
another splash screen with two important notices will appear:<br />
Warning: Do not use the M-Series imaging system as the primary navigation<br />
system. Use it in conjunction with a primary navigation system and<br />
other navigation aids.<br />
Note: The M-Series IR Thermal Imaging System is an Export Controlled<br />
item. Authorization by the U.S. Government must be obtained prior to<br />
export outside the United States.<br />
After the splash screens are displayed, the video screen will show a message<br />
that says “Loading, please wait...” 1 When the bootup is complete,<br />
the monitor will briefly show live video, and then the display will be<br />
blank, to indicate the camera is in Standby mode. The gimbal assembly<br />
20 432-0003-00-10 rev 140 M-Series Operator’s Manual