Download - Flir Systems

Configuration Menus
When the Enable or Disable selection is made, the camera prompts the
user to confirm or cancel the selection.
TABLE 1. Power Consumption
Camera
State Camera setting
The above power numbers assume a single JCU is plugged into the camera
and window heaters are not active. For a dual-payload camera, an additional
16W is consumed when window heaters are active for a maximum power
consumption of under 46 W. For single payload, when heaters are active
there is an additional 6.5W, for a maximum power consumption of under
26W.
Enable (Disable) Rearview Mode
This menu entry enables or disables the Rearview Mode, which causes the
video image to be flipped horizontally (revert). The image on the display provides
the same perspective as a rear view mirror in a vehicle - objects off
the stern on the starboard side of the vessel are displayed on the right hand
side of the video. If Rearview Mode is enabled, the Rearview mirror icon will
be displayed on the screen. It is possible to configure the USER button to
enable or disable the Rearview Mode.
Set Stow Position
Dual
Payload
Single
Payload
Standby High Power Mode ON
High Torque Mode ON
22W 17.4W
Standby High Power Mode OFF
High Torque Mode ON
8W 7.4W
Standby High Power Mode ON
High Torque Mode OFF
13W 13W
Standby High Power Mode OFF
High Torque Mode OFF
8W 7.4W
Awake High Power Mode ON or OFF
High Torque Mode ON
30W 19.4W
Awake High Power Mode ON or OFF
High Torque Mode OFF
20W 16.5W
When Set Stow Position is selected, the camera stores the current position
(camera azimuth and elevation) as the Stow position. The camera moves to
432-0003-00-10 rev 140 M-Series Operator’s Manual 37