Download - Flir Systems

Note: The center of the scan pattern
is determined by the direction
the camera is pointing when the
USER button is pressed. The scan
pattern is not centered about the
Home position, unless the camera
is in the Home position when the
USER button is pressed.
Configuration Menus
era to continuously pan left and right, until it is taken out of Surveillance
Mode or until the JCU is used to move the camera. The camera will not
resume Surveillance Mode automatically; it is necessary to enable Surveillance
Mode again by pressing the USER button.
Scan Width
In Surveillance Mode, the Scan Width determines the range of horizontal
azimuth (pan) covered by each scan. The choices are Narrow, Medium, and
Wide. If the Scan Width is set to Narrow, the camera will scan from approximately
20o left of center to 20o right of center, with the center determined
by which direction the camera is pointing when the USER button is pressed.
The Medium scan width covers an area 40 o to the left and right of center
(80o total), and the Wide scan width covers 80o to the left and right of center
(160 o total).
Scan Speed
Narrow
Medium
Wide
In Surveillance Mode, the Scan Width determines how quickly the camera
scans back and forth. The choices are Fast, Medium, and Slow.
Note: the scan speed is affected by the zoom state (if the camera is
zoomed in, it will scan at a slower rate). The default scan speed is Slow; try
all three settings to determine which is best for your installation.
432-0003-00-10 rev 140 M-Series Operator’s Manual 39