Download - Flir Systems
Download - Flir Systems
Download - Flir Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
JCU Power Menu<br />
Camera”. This indicates the user can scroll down with the puck to select a<br />
camera to control. When the desired camera name is shown in the display,<br />
press the puck to select that camera. The camera name will blink momentarily<br />
to indicate the camera has been selected.<br />
JCU Stndby?<br />
When the “JCU Stndby?” option is selected, the display momentarily shows<br />
“Goodbye” and then the backlit controls and the display are turned off. The<br />
JCU buttons and puck will no longer control the camera. The Power/DIM<br />
button remains backlit as long as power is supplied to the JCU. To power up<br />
the JCU again, press and hold the Power/DIM button.<br />
Camera Stndby?<br />
When the “Camera Stndby?” option is selected, the camera will move to<br />
the stowed (parked) position and the camera will go into the Standby state.<br />
Generally the stowed position is with the ball rotated down so the camera<br />
optics are in a protected position. The Stow position can be configured with<br />
the on-screen configuration menus.<br />
The JCU display will prompt the user to select a camera to control. If the<br />
same camera is selected, the camera will return to the Powered On mode.<br />
System Stndby?<br />
If the “System Stndby?” option is selected, both the JCU and camera are<br />
powered off, as described above.<br />
Global Stndby?<br />
Global standby is a command sent by a JCU that will power down all discovered<br />
cameras and JCUs. This function is used to properly shutdown all cameras<br />
(return to stow position) and JCUs prior to removing power with the<br />
system breaker. Selecting “Global Stndby?” directs the JCU to command all<br />
JCUs and cameras found on the network to go to standby mode. Global standby<br />
can also be achieved by pressing the SCENE, COLOR, and HOME buttons in unison<br />
for three seconds.<br />
Calibrate JCU<br />
The “Calibrate JCU” function is used to calibrate the JCU puck. This function<br />
might be used for example if the camera responds at a different rate<br />
when the puck is pushed left rather than right, or when the puck is twisted<br />
in one direction compared to the other. The JCU display directs the user to<br />
move and twist the puck in certain ways so the device can be calibrated.<br />
When calibrating, you will be instructed to move the puck to the maximum<br />
extent possible in each direction separately. After that has been done,<br />
pressing the puck moves to the next step. For example, "Rotate CW/CCW"<br />
requires rotating the puck CW to the full extent possible, and then rotating<br />
432-0003-00-10 rev 140 M-Series Operator’s Manual 25
Change language