Paper_Clip_Tutorial Part1.pdf - GaBi Software

Procedure
Then we assume that after the use phase, which has no environmental impact, the paper
clip will be thrown away. To model this you integrate a waste flow on the output side of
your use phase process.
71. Type in the output line ‘Steel scrap’ and choose the flow ‘Steel scrap (St)’ from
the object group ‘Waste for recovery.’
72. Enter the amount ‘0.00035kg.’
73. Save and close the process window.
74. On your life cycle plan connect the ‘Paper Clip Bending’ process with the ‘Use
Phase Steel Paper Clip’ process.
You will now add an End of life scenario. You will create the End of life scenario on a
separate plan. By doing this, you could put different waste treatment steps and variations
60