DANGER - Blemo

Programming
Menu structure
Two menu levels are provided.
"Easy start up" level - factory setting
Access to basic parameters which define the characteristics of the application to manage: acceleration ramp, boost level.
"Advanced level"
Access to dedicated parameters which define the characteristics of the motor protections, interface, communication,…
This selection will add some menus and, in the particular case of Monitoring menu, it will add some parameters.
Menu selection: "Easy start up" level or "Advanced" level
1. Scroll up or down using the forward and backward keys until you reach conF menu and press the ENT key. This enters Configuration
menu.
2. Scroll up or down using the forward and backward keys until you reach LAC setting in conF menu and press the ENT key.
3. Select the desired parameter (oFF for the easy start up level or On for the advanced level) then press the ENT key. Repeat for each
level of submenus and parameters until you reach the desired parameter and value.
4. Press the ENT key to save the value.
Note: A parameter value becomes valid and takes effect immediately upon changing its value. If ESC is pressed, the value previously stored
in the EEPROM is restored.
Menu description
(1)Status displays the state of the soft starter: rdY nrdY rUn.
See next page for Status menu.
46
Easy start up level Advanced level
Status (1)
conF
SEt
Actual Data
Configuration
Settings
SUP
Advanced
monitoring
Status (1)
conF
SEt
AdJ
SEt2
PrO
IO
COP
SUP
UtIL Utility
Actual Data
Configuration
Settings
Advanced
adjustments
Advanced
Settings
Advanced
protections
Advanced
I/O
Advanced
communication
Advanced
monitoring