DANGER - Blemo

Advanced communication menu (COP)
(1)Only available when Advanced mode LAC page 50 is set to On.
*: Write only when the soft starter is stopped.
62
Code Name/Description R/W Adjustment range Factory setting
COP Advanced communication menu
Add • Modbus address R/W* 1..247 oFF
oFF
1 to 247
- off
- Modbus address
Note: the modification will be taken into account only at the next control power on.
tbr • Modbus baudrate R/W* 4.8, 9.6, 19.2 Kbps 19.2 Kbps
Note: the modification will be taken into account only at the next control power on.
With the remote keypad, set 19.2 Kbps
For • Modbus format R/W* 8E1
8o1
8E1
8n1
8n2
- 8 bit, odd parity, 1 stop bit
- 8 bit, even parity, 1 stop bit
- 8 bit, no parity, 1 stop bit
- 8 bit, no parity, 2 stop bit
Note: the modification will be taken into account only at the next control power on.
With the remote keypad, set 8E1
ttO • Modbus time out
Note: 0.1s on keypad becomes 1 with Modbus (1/10th s value with Modbus).
Trip message is SLF.
LOSS OF CONTROL
WARNING
R/W* 0.1..60.0 s 5.0 s
Check that the selection of Modbus time out will not endanger personnel or equipment in any way.
Failure to follow this instruction can result in death or serious injury or equipment damage.
CtrL • Command channel R/W* LCL
LCL
dbS
- local command: with the control terminals
- remote command: Modbus
Note: During soft start and soft stop, parameters values written by Modbus are not taken into account.
LI1 must be activated (LI1 = 1) to allow the remote command.