SYCON.net PROFIBUS MPI DTM (Operating Instruction Manual)
SYCON.net PROFIBUS MPI DTM (Operating Instruction Manual)
SYCON.net PROFIBUS MPI DTM (Operating Instruction Manual)
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Online Functions 92/119<br />
7.4 Start /Stop Communication<br />
You can manually start or stop the communication at the <strong>PROFIBUS</strong> <strong>MPI</strong><br />
<strong>net</strong>work.<br />
• Start Communication is enabled, if the communication has been<br />
stopped before or if the configuration requires this (Controlled release of<br />
communication).<br />
• Stop Communication is enabled, if the communication has been<br />
started.<br />
To start or to stop the communication, proceed as follows:<br />
Start Communication<br />
1. Connecting Device:<br />
Note: To start the communication of the device at the bus manually, an<br />
online connection from the <strong>PROFIBUS</strong> <strong>MPI</strong> <strong>DTM</strong> to the <strong>PROFIBUS</strong> <strong>MPI</strong><br />
device is required.<br />
Further information can be found in the Connecting/Disconnecting Device<br />
section on page 77.<br />
2. Select Additional Functions > Service > Start Communication from<br />
the context menu (right mouse click).<br />
The device communicates at the bus.<br />
Stop Communication<br />
1. Select Additional Functions > Service > Stop Communication from<br />
the context menu (right mouse click).<br />
The communication of the device at the bus is stopped.<br />
<strong>DTM</strong> for Hilscher <strong>PROFIBUS</strong> <strong>MPI</strong> Devices | Configuration of Hilscher <strong>MPI</strong> Devices<br />
DOC0110402OI01EN | Revision 01 | English | 2011-07 | In Development | Public © Hilscher, 2007-2011
Change language