ePrism User Guide - EdgeWave

Cluster Management
4. When the system is restored, disable clustering on the cluster network interface in Basic
Config -> Network. Click the Update button but do not reboot.
5. Re-enable clustering on the network interface. Ensure that the specified interface is the one
connected to the cluster network. Click the Update button but do not reboot.
6. Connect the member system’s network cable to the cluster network.
7. From the Cluster Console, add the system back into the cluster.
Restoring the Cluster Console
On each cluster member system, (not the Cluster Console) clear the cluster configuration as
follows:
1. Disable clustering on the cluster network interface of each cluster member in Basic Config ->
Network. Click the Update button but do not reboot. Re-enable clustering on the network
interface. Ensure that the specified interface is the one connected to the cluster network. Click
the Update button but do not reboot.
2. Disconnect the Cluster Console from the cluster network via the network cable.
3. On the Cluster Console, perform a full restore of all configuration items.
4. When the restore is complete, go to the cluster configuration screen in HALO -> Cluster
Administration, and remove all cluster members from the cluster.
5. Reconnect the Cluster Console to the cluster network.
6. Reconfigure the cluster and add the other systems as cluster members.
215