user's manual - Ana-Digi Systems
user's manual - Ana-Digi Systems
user's manual - Ana-Digi Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CHAPTER 6 COMMUNICATION FUNCTION<br />
6.1.7 High speed link parameter setting in KGLWIN<br />
Profibus-DP master for MASTER-K also use a SyCon for Configuration setting and the setting<br />
method is also same as GLOFA-GM. For MASTER-K, it is required to set the high speed link<br />
parameter after downloading the Configuration to master module and high speed link<br />
parameter selects the parameter from KGLWIN project screen and set the relevant items. The<br />
setting procedure and the function of each item are as follows :<br />
1) High speed link parameter setting in KGLWIN<br />
If you select the parameter from the following project basic screen, the high speed link<br />
parameter basic screen appears and you can select the relevant items.<br />
KGLWIN Project basic screen<br />
2) High speed link parameter select<br />
A) Setting method<br />
Select the relevant parameter from the basic screen as shown on the figure below and<br />
enter into the parameter setting.<br />
Parameter setting basic screen<br />
2 Set ‘Link-<br />
Enable’<br />
1 When<br />
parameter<br />
window is open,<br />
press “link1”<br />
tab to set high<br />
speed link<br />
parameter.<br />
3 Set the base<br />
no. , the current<br />
master module<br />
is loaded, slot<br />
no. and Pnet<br />
6-22
Change language