You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
24 Getting Started<br />
1.2 Installing the USIM/SIM Card, Storage Card<br />
and Battery, and Charging the PDA Phone<br />
Always turn off your device before installing or replacing the USIM/SIM card,<br />
storage card, and battery. You also need to remove the back cover before you<br />
can install these components.<br />
To remove the back cover<br />
1. Make sure your device is<br />
turned off.<br />
2. Place the device face down on<br />
a clean and stable surface.<br />
USIM/SIM card slot<br />
Battery bay<br />
3. Slide up the battery<br />
compartment cover, then flip<br />
it down to access the battery<br />
bay, USIM/SIM card slot, and miniSD card slot<br />
miniSD card slot.<br />
Note To close the battery compartment cover, flip it up and align it with the battery<br />
compartment, then slide it down until it fits into place.<br />
USIM/SIM card<br />
The 3G USIM (Universal Subscriber Identity Module) or SIM (Subscriber Identity<br />
Module) card contains your phone number, service details, and phonebook/<br />
message memory. Your device supports both 1.8V and 3V USIM/SIM cards.<br />
Note<br />
Some legacy SIM cards may not function with your device. You should consult<br />
with your service provider for a replacement SIM card. There may be fees for this<br />
service.<br />
To install the USIM/SIM card<br />
1. Make sure your device is<br />
turned off.<br />
2. Locate the USIM/SIM card<br />
slot inside the battery<br />
compartment, then flip up the<br />
USIM/SIM card slot door.<br />
USIM/SIM card<br />
slot door
Change language