SMX Programming Manual for the SMX Module - OEM Automatic AB

Generate report
Generation of a validation report.
Disable configuration
After each transfer of configuration data to an SMX-system, these data are marked
as "not validated". The basic group signalizes this by means of a yellow flashing of
the status LED. The command "Disable configuration" disables access to the
configuration data in the basic group. This is indicated by a green flashing status
LED.
Read out binary file from SMX…
Reads out the current SMX equipment configuration in a machine readable from.
These data are not changed by SafePLC and can be saved to the drive in this form.
Send binary file to SMX…
Transfer of a machine readable equipment configuration from the PC drive to the
SMX-system.
Note:
When transferring machine readable program and parameter data, organizational
measures must be applied to ensure that the currently valid equipment configuration
conforms with the safety related documentation of the machine or system.
Diagnostic Functions
When clicking on the diagnostics button the connection dialog is extended by
additional diagnostics elements.
Diagnose Start: Two-way switch to start and stop the diagnose: The corresponding
mode ( = Off = On) is also displayed in the dialog text, so that feedback about
the current status is available, even in case of a minimized dialog. After successful
starting of the diagnose, the inscription of the switch will change to "Diagnose Stop".
Note: A correct diagnose requires the adjustment of data between logic diagram and
equipment configuration. A missing logic diagram or a discrepancy between the
available logic diagram and the equipment configuration only permits a limited
diagnose. The functionality "Diagnose function modules" is in this case not available.
Programming Manual – SMX Basic Modules 29.10.2009 Page 24 of 183