SMX Programming Manual for the SMX Module - OEM Automatic AB

With monitored starting mode an additional connector for linking with a start
element is provided. Here one can configure the continuous behaviour for
monitoring the inPort element during the start phase.
Start test
Manual starting after equipment reset or interruption of the defined safety circuit,
including testing of the connected control station. The control station must trigger
once in monitoring direction and switch back on again. Followed by normal
operation. This non-recurrent triggering of the inPort element when starting (or
resetting) the monitored equipment ensures the function of the inPort element at
the time of starting. A start test can be performed for all inPort elements, except
the mode selector switch.
An activated start test is indicated by a red rectangle on an added function block.
Normally closed
contact
Comment
Input of a comment text to appear on the module.
Enable switch
Switch type Designation Comment
1 (eSwitch_1o) 1 normally closed Enable switch standard
2 (eSwitch_1s) 1 normally open Enable switch standard
3 (eSwitch_2o) 2 normally closed Enable switch higher
requirements
4 (eSwitch_2oT) 2 normally closed time
monitored
Enable switch monitored
Programming Manual – SMX Basic Modules 29.10.2009 Page 44 of 183