cmd6686gx manual - RTD Embedded Technologies, Inc.
cmd6686gx manual - RTD Embedded Technologies, Inc.
cmd6686gx manual - RTD Embedded Technologies, Inc.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Default Configuration<br />
In addition to the Setup configuration stored on the board, the cpuModule has a permanent default<br />
configuration. The system will resort to using this default if an error occurs when accessing the<br />
EPROM which holds the Setup on the module.<br />
The default configuration is listed below.<br />
BIOS Default Configuration<br />
Function<br />
Default selection<br />
IDE Interface 0 Master<br />
Auto detect<br />
IDE Interface 0 Slave<br />
Auto detect<br />
IDE Interface 1 Master<br />
Auto detect<br />
IDE Interface 1 Slave<br />
Auto detect<br />
Boot device Floppy then hard disk<br />
BIOS Extension<br />
Disabled<br />
Floppy Drive 1<br />
3.5" 1.44 Meg<br />
Floppy Drive 2<br />
not installed<br />
Serial port 1<br />
RS232 at 3F8H<br />
Serial port 2<br />
RS232 at 2F8H<br />
Parallel Port<br />
LPT1 at 378H<br />
Keyboard<br />
Enabled if connected<br />
USB<br />
Enable if connected<br />
Fail safe boot rom<br />
Enabled<br />
85