cmd6686gx manual - RTD Embedded Technologies, Inc.
cmd6686gx manual - RTD Embedded Technologies, Inc.
cmd6686gx manual - RTD Embedded Technologies, Inc.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
I/O Connections<br />
The cpuModule comes from the factory ready to connect to the peripherals shown in the following<br />
table.<br />
Default Peripheral Settings<br />
Item Setting Controlled by<br />
Boot device Floppy / DOC Setup<br />
SSD Power 5V on board or battery Jumper<br />
Serial Port #1 RS232 at 3F8H, IRQ 4 Setup<br />
Serial Port #2 RS232 at 2F8H, IRQ 3 Setup<br />
USB Ports<br />
#1 and #2<br />
Enabled<br />
Setup<br />
Parallel Port Bi-directional at 378H,<br />
IRQ 7<br />
Setup<br />
Floppy Drive 1 1.44M 3.5" Setup<br />
Floppy Drive 2 Not installed Setup<br />
All IDE Drives Auto Detect Setup<br />
If you are using peripherals compatible with this list, you do not need to configure any jumpers or<br />
software settings before connecting them. If you are using different peripherals, you may need to<br />
change the cpuModule settings. In that case, please see Configuring with the <strong>RTD</strong> Enhanced<br />
Award BIOS.<br />
28
Change language