User Guide and Manual for Project Canary

More documents

Recommendations

Info

4.11.9: Average number of processes per non-system user This graph shows the number of processes spawned by CDE desktop users to operate their environment. Note that usage spikes, then tapers off and only a few users are “driving” their desktop environment. User Guide and Manual for Project Canary Page 94
4.11.10: Total resident memory consumed for all applications by a user This graph shows the amount of resident memory consumed for all applications by a user who is using the CDE desktop. Note that at around 400mb per user, utilization drops rapidly with the exception of the few power-users at the end of the graph. User Guide and Manual for Project Canary Page 95
Page 1 and 2:
User Guide and Manual for Project C
Page 3 and 4:
Chapter 1: Project Canary Overview.
Page 5 and 6:
4.13: Graph PID[s] Report..........
Page 7 and 8:
4. /usr/bin/uptime 5. /usr/bin/prst
Page 9 and 10:
client being monitored. A ten minut
Page 11 and 12:
On this page, one sees a basic guid
Page 13 and 14:
Here one can access the various rep
Page 15 and 16:
By default, servers are grouped int
Page 17 and 18:
As shown above, clicking on a “Ca
Page 19 and 20:
This page shows when the Project Ca
Page 21 and 22:
Each of the graphs shown in the pre
Page 23 and 24:
Scrolling down on the page will rev
Page 25 and 26:
Below is a graph taken from a typic
Page 27 and 28:
The Blue line shows how many iterat
Page 29 and 30:
This graph shows how many interrupt
Page 31 and 32:
On a Sun Ray server with multiple u
Page 33 and 34:
using it. If the red CPU utilizatio
Page 35 and 36:
A Sun Ray server or diskless workst
Page 37 and 38:
perform cross-architecture communic
Page 39 and 40:
The X-axis shows the number of proc
Page 41 and 42:
These statistics are collected from
Page 43 and 44: Note again, there are spikes at nig
Page 45 and 46: The network appears to be fairly sp
Page 47 and 48: From this graph, it would appear th
Page 49 and 50: The Data Center server is not runni
Page 51 and 52: Since the data center server is not
Page 53 and 54: The graph above shows that the data
Page 55 and 56: As the previous graphs have shown,
Page 57 and 58: Older versions of Sun Ray Server So
Page 59 and 60: When clicking on the Reports Tab, o
Page 61 and 62: The above is an example. To create
Page 63 and 64: From this screen, one must select a
Page 65 and 66: As described previously, this table
Page 67 and 68: This report is identical to the “
Page 69 and 70: The CPU Load (animated) report show
Page 71 and 72: systems administrator is advised to
Page 73 and 74: There are four reports on various c
Page 75 and 76: As described earlier in this docume
Page 77 and 78: As with all reports available from
Page 79 and 80: This graph is useful to see if the
Page 81 and 82: This chart is useful for monitoring
Page 83 and 84: As shown above, users who have logi
Page 85 and 86: From the graph shown on the previou
Page 87 and 88: as CDE and GNOME which have been se
Page 89 and 90: 4.11.4: Total Resident Memory Consu
Page 91 and 92: 4.11.6: Total CPU Minutes Used for
Page 93: 4.11.8: Percentage of memory consum
Page 97 and 98: 4.11.12: Total CPU minutes consumed
Page 99 and 100: 4.11.14: Percentage of server memor
Page 101 and 102: Also note the power-user at the end
Page 103 and 104: 4.11.18: Total CPU minutes for all
Page 105 and 106: The CPU Profiles report page looks
Page 107 and 108: Note that peaks and valleys appear
Page 109 and 110: As with the automount png graph des
Page 111 and 112: Note that while ncsd doesn't appear
Page 113 and 114: Here on this graph, it is shown tha
Page 115 and 116: utdsd, like other system service da
Page 117 and 118: The main purpose of this report is
Page 119 and 120: Overview of Project Canary Software
Page 121 and 122: management system. A2.2: I don't wa
Page 123 and 124: Crypto 74 Crypto Settings report 78
Page 125 and 126: unaway processes 9, 12, 16, 23p., 6
show all

User Guide and Manual for Project Canary

Create successful ePaper yourself

Delete template?

Save as template?