Release Notes: Version E.10.37 Software

Software Fixes in Release E.06.xx through E.10.xx
Release E.10.04
■
Config (PR_1000246102) - The show config command indicates a configuration file named
"config" already exists.
Release E.10.04
Problems Resolved in Release E.10.04
■
■
■
Console/TELNET (PR_1000278912) - The 5300xl console will lock up when connected
via the console port and attempting to establish a TELNET connection into a remote switch.
Meshing (PR_1000218463) - If a mesh link goes down and a redundant (xSTP) link
external to the mesh goes into a forwarding state, connectivity across the mesh may be lost
for a previously learned MAC address.
SNMP (PR_1000003378) - SNMP switch time may drift with event log updates occurring
every 1.5 hours.
Release E.10.05
Problems Resolved in Release E.10.05
■
■
■
■
■
■
■
ACL (PR_1000283338) - The commands "show port-access mac" and "show port-access
web" incorrectly display the number of clients authenticated.
Crash (PR_1000282444) - When enabling OSPF MD5, the switch may crash with a message
similar to:
Software exception at exception.c:373 -- in 'mSess1’.
mini-GBIC (PR_1000283081) — After hot-swapping a mini-GBIC, the Link and Activity
LEDs do not turn on.
mini-GBIC (PR_1000283082) — Some Gigabit LX mini-GBICs may fail when the mini-
GBIC switch module is hot-swapped.
mini-GBIC (PR_1000283084) — When a mini-GBIC is removed from the module, the Fault
and Port LEDs will continue to flash.
RADIUS (PR_1000285456) — If more than one RADIUS assigned vendor specific attribute
(including Port-cos, rate-limiting-ingress, or ACLs) is configured with a non-vendor specific
attribute, only the first vendor specific attribute may be recognized by switch.
Web UI/mini-GBIC (PR_1000279145) — When using the web user interface, the switch
will not display an indication of the Gigabit 1000Base-T mini-GBIC (J8177B) from the
Configuration tab "Device View".
49