GENEVA - Vending Machines

COFFEtek Ltd
(e)
HARDWARE SETTINGS
This submenu allows some machine components to be disabled to allow limited
functionality to be restored in the event of a failure. For example, in the event that one of
the cup sensor PCBs fails, it is possible to inform the control system that these are not
fitted. Likewise in the event of a brewer failure setting the COFFEE BREWER to NO will
allow any selections not reliant on the brewer to operate. Whilst all possible system
components are visible in this submenu, irrespective of the machines configuration, it is
only meaningful to ENABLE components that actually exist in the machine. Thus it
makes no sense to set TEA BREWER to YES on an all-instant machine and indeed will
result in an IO MAPPING ERROR.
CUP SENSORS
PARAMETER
DISPENSE ARM
TEA BREWER
COFFEE BREWER
COLD UNIT
HW HOT HEAD (NO)
SNACK SLAVE (NO)
Caution - Setting this variable
manually using this menu will
result in an incorrectly configured
machine. Don’t do it!
SLAVE P’COL (NO)
Caution - Setting this variable
manually using this menu will
result in an incorrectly configured
machine. Don’t do it!
FUNCTION
Enable/disable user cup sensors.
Default is YES - sensors fitted.
Enable moving dispense head.
Default is YES. Can be usefully disabled only
for diagnostics. The machine cannot operate
with this item deselected.
Enable tea brewer.
Default for fresh brew machine configurations is
YES; for Instant configurations NO.
Enable coffee brewer.
Default for double fresh brew configurations is
YES; instant and single fresh brew
configurations NO.
Indicates the type of cold drinks unit installed.
Possible values are:
• HOT ONLY
• CARBONATOR
• CHILLER
• CHILLER+SYRUP
Hot water dispense is physically located on the
hot drink dispense position on the dispense
head. Default is NO
A Plus 7 board and loom are fitted to enable
slave operation of a CB300 can and bottle
slave.
Note This is the means by which such a unit is
disabled. Setting this to ON will result in an
incorrectly set up machine. The INST’ SNACK
SLAVE submenu of CONFIGURE M/C should
be used install a slave. This will result in this
variable being set.
The machine is configured for connection to a
Coffetek Water or Soup Salve via the Coffetek
Slave Protocol.
Note This is the means by which such a unit is
disabled. Setting this to ON will result in an
incorrectly set up machine. The INITIALISE
SLAVE submenu of the CONFIGURE SLAVE
MENU should be used install a slave. This will
result in this variable being set.
69 06/08/2008 Issue 3 GENEVA