GENEVA - Vending Machines

COFFEtek Ltd
(f)
CAROUSEL CONFIG
This informs the machine what type of carousel configuration is fitted. The default for all
of the predefined configurations assumes a single 600 cup plastic cup drop unit, Part No
89332, is fitted. Table 3.5, shows the possible values and corresponding physical
hardware it implies: Note for Two Cup Types and Two Cup Sizes it is preferable to set
these by choosing an appropriate configuration via SET MACHINE TYPE than using this
menu. If set using this menu it is necessary to restart the machine before using the SET
CUP types menu to define the carousel associated with each selection. For two carousel
types the designation of carousel 1 & two is as follows:
Carousel
2
(Large Cup)
Carousel
1
FIG. 3.1 TWIN CAROUSEL DESIGNATIONS
NONE
VALUE
PHYSICAL SET UP
No cup drop mechanism is present. User supplies own cup.
2 Cup Types Two different types of cup are available.
2 Cup Sizes Two different Sizes of cup available. Set this and then use
SET INGREDIENTS to change the two sizes. You must cycle
the power after changing this variable.
SINGLE
Standard Plastic 600 cup capacity unit.
1000 CUP Allows 1000* (*=Typically 950) cups of the same size to be put
into a double cup drop system. This system needs to be
loaded into the right hand cup drop first.
TABLE 3.5
(g)
INSTALL SNACK SLAVE
By entering this section it will allow a Plus 7 board and loom are fitted to enable slave
operation of a CB300 can and bottle slave. The operation of the slave units is outside
the scope of this manual.
GENEVA Issue 3 06/08/2008 70