Versamark DS5600 Series - Kodak
Versamark DS5600 Series - Kodak
Versamark DS5600 Series - Kodak
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 2. Operation<br />
Startup Procedures<br />
The CS150 System Controller is primarily used with the <strong>Kodak</strong> <strong>Versamark</strong><br />
D-<strong>Series</strong> Printing Systems for applications that require bar coding,<br />
numbering, addressing, and personalizing. The CS150 can operate up to<br />
four printheads in various combinations (See “<strong>DS5600</strong> Configurations” on<br />
page 11). The feature key for the CS150 software must match the number<br />
and type of printheads being used.<br />
Startup Procedures<br />
Narrow-format printers should be powered-up normally before the<br />
controller is started. For a system a with DS5000 series enclosure, startup<br />
is done exactly the same as described in the <strong>Kodak</strong> <strong>Versamark</strong> CS150<br />
System Controller Software Getting Started Guide. Review the following<br />
procedures before starting the system initially:<br />
• System Connections<br />
• Startup Sequence<br />
System Connections<br />
For a system without a DS5000 series enclosure, check all the<br />
connections to the controller mounted under the shelf on the DT3 cabinet<br />
(Figure 2.1).<br />
Figure 2.1<br />
Connections, CS150 controller on DT3 cabinet<br />
Monitor power<br />
Data from controller<br />
Data out to printer<br />
Data from customer network<br />
PC power<br />
KVM for CS150<br />
CS150 software key<br />
KVM switch input<br />
KVM switch<br />
KVM for DT3<br />
Data output<br />
Operator Guide 19