Versamark DS5600 Series - Kodak

Chapter 2. Operation
Controller Operation
Device Configuration
To print, each printer must be configured in the CS150 software. Use the
following procedure to assign each printer to a service and configure that
printer for use by the system:
1. In the Dashboard window, select Diagnostics. The Diagnostics
window appears.
Unknown
2. Select Services New Service (or press CTRL + INSERT) to create a
service view for each printer or print station connected to the
controller. An Unknown device icon appears (see example at left) and
the Select Service dialog appears (Figure 2.6).
Figure 2.6
Select service setup window, CS150 software
3. Select Kodak Service and click OK. The Service Dialog appears.
4. Select the correct IP address for the device from the drop-down
menu and then click OK.
Note:
The address selected must be set using DIP switches on the Compact DS
Main Board in the printer or print station, and two devices cannot have the
same address. If the address does not match the hardware setting, the
warning “this device is not connected” appears when the device icon is
selected. Contact your supervisor or a service technician if a device
address needs to be changed. When the new device connects, select it
by double-clicking the New Device icon in the list under Services. A
dialog appears asking you to name the new device.
24 DS5600 Series Printing Systems