Versamark DS5600 Series - Kodak

Chapter 4. Operator Maintenance
Weekly Maintenance
Weekly Maintenance
The following maintenance procedures are required for Kodak Versamark
DS5600 Printing Systems components:
• Printhead air filter replacement
Only the wide-format printheads (Kodak Versamark DH5300, Kodak
Versamark DH6240, and Kodak Versamark DH6300) have this filter.
• Cabinet air filter
Both printers and print stations have this filter.
Printhead Air Filter
Inspect the printhead air filter on the wide-format printheads for dirt, paper
dust, ink, or any other debris. If the filter is coated, replace it. Remove the
filter from its bracket by pulling up on the tab (Figure 4.1).
Figure 4.1
Printhead air filter, DH6240
Air filter tab
Cabinet Air Filter
Inspect the cabinet air filter for dirt, paper dust, ink, or any other debris. If
the filter is coated, remove it and clean it with ordinary tap water or D.I.
water and mild detergent. Let the filter air dry. Install a replacement filter
while the cleaned filter dries. If cleaning fails to restore the original
appearance of the filter, replace it.
Note: The filter bracket is mounted horizontally on the Kodak Versamark DT3
Print Station (Figure 4.2), but vertically on narrow-format printers. The
removal and cleaning procedure is the same for both filters.
Figure 4.2
Cabinet filter, DT3 print station
Air filter bracket
48 DS5600 Series Printing Systems