03.11.2014 Views

developer policy manual - Grand Strand Water and Sewer Authority

developer policy manual - Grand Strand Water and Sewer Authority

developer policy manual - Grand Strand Water and Sewer Authority

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

CONSTRUCTION PROCEDURES<br />

CHAPTER THREE<br />

3.2.2 Wet Taps<br />

Where the extension of a water main or force main is necessary, the<br />

<strong>Authority</strong> shall make all wet taps unless conditions warrant a waiver of<br />

this requirement by the <strong>Authority</strong>. If the <strong>Authority</strong> elects to allow a<br />

contractor to make a wet tap, the contractor shall coordinate the tap with<br />

the <strong>Authority</strong> for an acceptable time <strong>and</strong> assignment of an inspector to<br />

monitor the tapping procedure.<br />

3.2.3 ACCESS<br />

The <strong>Authority</strong> shall have access to the project premises during reasonable<br />

hours to perform inspections to ensure compliance with construction<br />

requirements.<br />

3.2.4 SEWER EXTENSIONS<br />

Extensions from existing manholes must be performed in the presence of<br />

an <strong>Authority</strong> inspector. Upon completion of the first section of gravity<br />

sewer, the contractor is required to plug the extension. The plug is not to<br />

be removed until service authorization is given. Failure to meet this<br />

provision violates Section 11 of Act 337 of the Acts <strong>and</strong> Joint Resolutions<br />

of the State of South Carolina of 1971, therefore, making the contractor<br />

subject to fines <strong>and</strong>/or imprisonment.<br />

3.2.5 CONSTRUCTION OF A MANHOLE OVER EXISTING GRAVITY<br />

SEWER LINES<br />

Manholes shall be constructed in the presence of the <strong>Authority</strong>'s inspector.<br />

Any manhole constructed on an existing line must be approved by an<br />

<strong>Authority</strong> inspector prior to cutting into the existing operational sewer<br />

line.<br />

3.2.6 FORCE MAIN TIE INS<br />

All tie-ins of force mains into existing manholes must be done in the<br />

presence of an <strong>Authority</strong> inspector.<br />

3.3 WATER USE POLICY<br />

3.3.1 CONSTRUCTION WATER<br />

Filling <strong>and</strong> flushing of new water mains consumes large quantities of nonmetered<br />

water over the period of system construction. The methods for<br />

contractors utilizing water for construction purposes <strong>and</strong> coordination with<br />

<strong>Authority</strong> personnel are the responsibility of the contractor.<br />

Construction Procedures July 2009 <strong>Gr<strong>and</strong></strong> <strong>Str<strong>and</strong></strong> <strong>Water</strong> <strong>and</strong> <strong>Sewer</strong> <strong>Authority</strong><br />

Page 18<br />

Developer Policy Manual

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!