3000 Series Articulator and Quick Mount Face-Bow ... - Whip Mix

More documents

Recommendations

Info

Setting The Condylar Guidance Of The MODEL 3040 Articulator Fig. 104 After removing the CR or MI registration, release the centric latch. Fig. 105 Release the elastics. Fig. 106 Set both condylar guides to the 0° setting indicated on the condylar inclination scale — firmly tighten the left condylar guide locking screw and lightly secure the right condylar guide locking screw. Fig. 107 Note: Set the progressive side shift guides to their most open position. 36
Fig. 108 Loosen the incisal guide pin screw. Raise the incisal guide pin to prevent any interference and retighten the screw. Fig. 109 With the upper frame and its cast inverted, carefully seat the left lateral excursion interocclusal record on the maxillary cast. Fig. 110 Lightly holding the articulator together, make sure the left condyle is seated “flush” against the rear wall. Gently seat the lower cast into the left lateral record and lightly hold the articulator and casts in position. Note: The teeth of the cast should seat evenly into the left lateral record. If the posterior teeth are raised out of the record, the condylar inclination needs to be decreased until the teeth are seated evenly in the record. Fig. 111 To set the inclination of the right condylar guide, carefully loosen the #2432 Clamp Knob and rotate the guide until the teeth of the upper cast seat evenly in the left lateral record. It is advisable when making these adjustments that the contact should also be judged by sight, rather than depending solely on the sense of touch. This helps to ensure the casts are not forced out of position. 37
Page 1 and 2: 3000 Series Articulator and Quick M
Page 3 and 4: CONTENTS INTRODUCTION 5 OBTAINING F
Page 5 and 6: INTRODUCTION WHIP MIX Articulators
Page 7 and 8: Fig. 5 Loosen the #8604 Thumb Screw
Page 9 and 10: Fig. 13 Inspect the registration fo
Page 11 and 12: Fig. 20 Tighten the center #8604 Th
Page 13 and 14: V. Obtaining Interocclusal Records
Page 15 and 16: Fig. 34 Remove and examine the cent
Page 17 and 18: Fig. 41 Manipulate the mandible int
Page 20 and 21: DIRECT Mounting THE MAXILLARY Cast
Page 22 and 23: Fig. 53 Note: Set each condylar gui
Page 24 and 25: Fig. 60 Hold the face-bow in one ha
Page 26 and 27: Fig. 68 The #28706 Face-Bow Fork Su
Page 28 and 29: INDIRECT Mounting THE MAXILLARY Cas
Page 30 and 31: I. Preparing The Face-Bow And Artic
Page 32 and 33: III. Mounting The Maxillary Cast Fi
Page 34 and 35: Fig. 97 Place the articulator upsid
Page 38 and 39: Fig. 112 Tighten the #2432 Clamp Kn
Page 40 and 41: SeTTING THE CONDYLAR GUIDANCE OF TH
Page 42 and 43: Fig. 127 To prevent possible wearin
Page 44 and 45: III. Preparing Face-Bow Armamentari
Page 46 and 47: VI. Preparing The Articulator For M
Page 48 and 49: VIII. Mounting The Mandibular Cast
Page 50 and 51: Fig. 159 Set condylar inclinations
Page 52 and 53: Interchangeability With The Model 3
Page 54 and 55: Maintenance The Whip Mix Model 3040
Page 56 and 57: Model 3140 Articulator # PART# QTY.
Page 58 and 59: model 9600 face-bow For Direct Moun
Page 60 and 61: MODELS 9275/ 9285/9295 FACE-BOWS FO
Page 62 and 63: NOTES _____________________________
Page 64: For additional information, contact

3000 Series Articulator and Quick Mount Face-Bow ... - Whip Mix

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?