3000 Series Articulator and Quick Mount Face-Bow ... - Whip Mix

More documents

Recommendations

Info

SeTTING THE CONDYLAR GUIDANCE OF THE MODEL 3140 ARTICULATOR Fig. 119 Follow the technique recommended for setting the condylar guidance of the Model 3040 Articulator, Fig. 104–118 (p. 36–39). Next, with the upper frame and its cast inverted, carefully seat the right lateral interocclusal record on the upper cast. Holding the upper frame with one hand and the lower frame in the other, place the right (working) condylar element in the right condylar guide. Make sure the right condyle element is seated “flush” against the rear wall. Gently seat the lower cast into the right lateral record and tightly hold the articulator and casts in position on the right side. Fig. 120 Notice that the left condylar element has moved away from both the superior and posterior surface of the condylar guide and toward the medial wall. Fig. 121 To set the inclination of the left condylar guide, carefully loosen its clamp knob and rotate the guide until the superior wall touches the condyle element. It is advisable when making these adjustments, that the contact should also be judged by sight, rather than depending solely on the sense of touch. This helps to ensure that the casts are not forced out of position. Fig. 122 Tighten the #2432 Clamp Knob to secure the guide in position. DO NOT USE EXCESSIVE PRESSURE when tightening the clamp knob. 40
Fig. 123 To set the left progressive side shift guide, loosen the left #8520A Locking Screw and move the #2406 Left Side Shift Guide until it touches the side of the condyle element and retighten the #8520A Locking Screw. Fig. 124 After the left condylar guidance has been recorded, the condylar guidance should be neutralized as previously described. Next, the right condylar guidance is adjusted using the left lateral excursion record and repeating the above procedure. Fig. 125 Many wish to set the condylar inclination of the articulator with a protrusive record. To utilize the protrusive record, first neutralize the condylar inclination and progressive side shift settings. Place the protrusive record on the inverted upper frame of the articulator and gently seat the lower cast into the protrusive record. Both condylar elements will have moved away from the posterior and superior surfaces of their respective condylar guide assemblies. Fig. 126 Using sight and touch, rotate the right condylar guide until it contacts the condylar ball, then tighten the #2432 Clamp Knob. Record the reading and repeat the procedure on the left side. The right and left lateral records are then used to determine the progressive side shift settings. 41
Page 1 and 2: 3000 Series Articulator and Quick M
Page 3 and 4: CONTENTS INTRODUCTION 5 OBTAINING F
Page 5 and 6: INTRODUCTION WHIP MIX Articulators
Page 7 and 8: Fig. 5 Loosen the #8604 Thumb Screw
Page 9 and 10: Fig. 13 Inspect the registration fo
Page 11 and 12: Fig. 20 Tighten the center #8604 Th
Page 13 and 14: V. Obtaining Interocclusal Records
Page 15 and 16: Fig. 34 Remove and examine the cent
Page 17 and 18: Fig. 41 Manipulate the mandible int
Page 20 and 21: DIRECT Mounting THE MAXILLARY Cast
Page 22 and 23: Fig. 53 Note: Set each condylar gui
Page 24 and 25: Fig. 60 Hold the face-bow in one ha
Page 26 and 27: Fig. 68 The #28706 Face-Bow Fork Su
Page 28 and 29: INDIRECT Mounting THE MAXILLARY Cas
Page 30 and 31: I. Preparing The Face-Bow And Artic
Page 32 and 33: III. Mounting The Maxillary Cast Fi
Page 34 and 35: Fig. 97 Place the articulator upsid
Page 36 and 37: Setting The Condylar Guidance Of Th
Page 38 and 39: Fig. 112 Tighten the #2432 Clamp Kn
Page 42 and 43: Fig. 127 To prevent possible wearin
Page 44 and 45: III. Preparing Face-Bow Armamentari
Page 46 and 47: VI. Preparing The Articulator For M
Page 48 and 49: VIII. Mounting The Mandibular Cast
Page 50 and 51: Fig. 159 Set condylar inclinations
Page 52 and 53: Interchangeability With The Model 3
Page 54 and 55: Maintenance The Whip Mix Model 3040
Page 56 and 57: Model 3140 Articulator # PART# QTY.
Page 58 and 59: model 9600 face-bow For Direct Moun
Page 60 and 61: MODELS 9275/ 9285/9295 FACE-BOWS FO
Page 62 and 63: NOTES _____________________________
Page 64: For additional information, contact

3000 Series Articulator and Quick Mount Face-Bow ... - Whip Mix

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?